h3c与思科6509装备端口集聚指令
h3c与思科6509装备端口集聚指令
首要创立vlan1031及装备与联通相应的IP地址。
#interface Vlan1031
description To-ROUTE-S9306-1-1G::GE_1/0/12-13
ip address 120.80.241.110 255.255.255.252
一、进入新增端口,并装备channel 3.
(config)#interface range GigabitEthernet3/15 - 16
(config-if)#no ip address
(config-if)#switchport access vlan 1032
(config-if)#channel-protocol lacp (此处是装备静态lacp)
(config-if)#channel-group 5 mode active(办法用ative可以让两头设备可以接纳和发送lacp数据包)
(config-if)#exit
#sh run int port-channel 3 (查看是不是主动发作了通道3)
查看port-channel 3是不是有以下装备,假定没有则手动增加。
switchport access vlan 1032
三、假定通讯正常。则进行路由装备。
路由装备因人而异。在此不贴出。仿制代码联通S9306装备集聚有关材料。
留神:改动Eth-Trunk作业办法前请首要确保该Eth-Trunk中没有参与任何成员接口,不然无法批改Eth-Trunk的作业办法。删去已存在的成员接口请在相应接口视图下施行指令undo eth-trunk trunk-id。
[Quidway] interface eth-trunk 5
[Quidway-Eth-Trunk2]mode lacp-static (此处是在S9306上装备静态lacp)
然后向Eth-Trunk中参与成员接口
施行指令system-view,进入体系视图。
施行指令interface interface-type interface-number,进入接口视图。
施行指令eth-trunk trunk-id,将接口参与Eth-Trunk仿制代码阐明:
静态LACP办法的Eth-Trunk不支撑以下类型的接口聚合:
千兆以太网接口与百兆以太网接口的聚合
上一篇:GPON体系构造图及运用